ST Quadrat LUX-top KLICK II Mode D'emploi page 20

 The installation documents verify to the user that the installation has been carried out
properly and provide the basis for subsequent inspections of the anchor device. A copy
should therefore be kept in the building
 You must comply with the relevant national regulations and the accident prevention
regulations during installation of the anchor device.
 The installers must take measures so that neither components of the anchor device nor
tools can fall from the work area.
Combination with other LUX-top
®
LUX-top KLICK II may only be used as a single anchor point.
Combination with horizontal anchor devices to EN 795 Type C is not possible.
Use / system description:
®
The LUX-top KLICK II
corresponding anchor sleeves by a self-locking mechanism. After testing the load-bearing
capacity of the installation substrate, the anchor sleeves can be installed in reinforced
concrete, steel or masonry parts of the building.
The anchor device can be loaded in all directions.
The maximum force input into the structure by the anchor device in case of a fall is 12 kN.
®
The LUX-top KLICK II
full body harnesses and energy absorbers (including 1 person for giving first aid / rescue).
An anchor point already deformed by a fall can still be used for the rescue of a person who
has fallen from a height.
The attachment to the
hook/carabiner to EN 362) of the PPE against falling, in accordance with its instructions for
use.
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection – www.st-quadrat.lu
products:
®
system is a stainless steel anchor point, which can be fixed in the
anchor device is approved for simultaneous use by 2 people with
®
LUX-top KLICK II
Page 5 Version 05/2015
system is made by means of a connector (spring