Installation Instructions - ST Quadrat LUX-top SDA-Z II Manuel De Montage

Installation Instructions

LUX-top SDA-Z II -
Anchoring point for the attachment of personal fall protection
systems
Preliminary note:
Prior to installation of the anchoring construction, the load capacity of the roof
construction must be checked. Please maintain the technical building regulations.
Only original parts of the anchoring system may be used. Note the installation and safety
information in the user instructions.
LUX – top
Fix the
lathe in the middle of the (min. 6/14 cm; min.
strength class C24 to DIN EN 338) as shown
in the following installation sketch using the
three woodscrew 8,0 x
(without predrilling).
NOTE: Please observe that the
LUX – top ®
SDA-Z II
that it can be inserted into the roof
cladding structure
IF THE REQUIRED MINIMUM ENGAGEMENT LENGTH IS NOT ENSURED DUE TO THE ROOF
CONSTRUCTION FOUND ON SITE, LONGER WOODSCREWS MUST REQUESTED FROM THE
MANUFACTURER!
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection solutions – www.lux-top-absturzsicherungen.de
®
SDA-Z II onto the cross-
L mm supplied
is positioned so
.
WOOD
Depending on the dimensions of the roof
lathing, level differences are to be
balanced out
underneath (recommendation: Euroklick
Type 2).
Screw length
existing roof structure.
Minimum engagement length
in the load-bearing structural member
(rafters) = 130 mm
Minimum rafter cross-section: 6 / 14 cm
The screws must be installed in the
smaller drill holes (diameter=10 mm)!
1
by inserting spacers
L is specified on the
Version 04/2015