Returning For Service - DeFelsko PosiTector RTR 3D Mode D'emploi

Before returning the Gage for service...
1.
Install new or newly recharged batteries in the proper alignment
as shown within battery compartment.
2.
Clean the measurement anvils using the cleaning card (pg. 9).
3. Perform a Hard Reset (pg. 13).
4.
Verify accuracy and operation (pg. 10)
5. If issue is not resolved, Update (pg. 28) your PosiTector gage
body and re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, please fill out and include the
Service Form located at www.defelsko.com/support with the Gage.
Be sure to also include the probe, your company name, company
contact, telephone number and fax number or email address.
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth
on its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiSoft and PosiTector are trademarks of DeFelsko Corporation registered in the
U.S. and in other countries. Other brand or product names are trademarks or registered
trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.

Returning for Service

and Limited Liability
www.defelsko.com
© 2017 DeFelsko Corporation USA All Rights Reserved