Returning For Service - DeFelsko PosiTest PCO Mode D'emploi

Before returning the instrument for service...
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the probe tip screen for dirt or damage.
Replacement screens are available for purchase.
3. Perform a Reset (pg. 3) and Zero (pg. 4).
If you must return the Gage for service, describe the problem fully
IMPORTANT:
and include measurement results, if any. Be sure to also include
the probe, your company name, company contact, telephone
number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted,
in whole or part, by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTest, PosiTector and PosiSoft
registered in the U.S. and in other countries. Other brand or product names are trademarks or
registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate.
DeFelsko is not responsible for printing or clerical errors.

Returning for Service

and Limited Liability
www.defelsko.com
© 2018 DeFelsko Corporation USA All Rights Reserved
are trademarks of DeFelsko Corporation
12