Probes; Certification - DeFelsko PosiTector RTR 3D Mode D'emploi

When powered-up, the PosiTector automatically determines which
probe is attached and does a self-check.
To disconnect a probe from a body, slide the plastic probe connector
horizontally (in the direction of the arrow) away from the body.
Reverse these steps to attach a new probe.
NOTE:
It is not necessary to power-down the gage when
interchanging probes.
Probe
Connector
Measurement
Opening
(Anvils)
Camera
PosiTector RTR probes include a Certificate of Calibration.
For organizations with re-certification requirements, instruments may
be returned at regular intervals for calibration.
DeFelsko recommends that customers establish calibration intervals
based upon their own experience and work environment. Based on
our product knowledge, data and customer feedback, a one year
calibration interval from either the date of calibration, date of
purchase, or date of receipt is a typical starting point.

Probes

PosiTector RTR 3D probe

Certification

Button-Operated
Spring Micrometer
applies constant
anvil pressure
4