Returning For Service - DeFelsko PosiTector SPG Mode D'emploi

Before returning the Gage for service...
1. Install new or newly recharged batteries in the proper alignment
as shown within battery compartment.
2. Examine the probe tip for dirt or damage. The probe tip should
move up and down freely. The metal plate surrounding the probe
tip should be smooth and free from burrs and foreign material.
3. Perform a Hard Reset. (pg. 4)
4. Place the metal shim over the glass plate and attempt a
measurement.
5. If issue is not resolved, Update (pg. 8) your PosiTector gage
body and re-attempt measurements.
IMPORTANT:
If you must return the Gage for service, describe the problem fully
and include measurement results, if any. Be sure to also include the
probe, your company name, company contact, telephone number
and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole or part,
by any means, without written permission from DeFelsko Corporation.
DeFelsko, PosiTector and PosiSoft are trademarks of DeFelsko Corporation registered in the U.S. and in other
countries. Other brand or product names are trademarks or registered trademarks of their respective holders.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

and Limited Liability
www.defelsko.com
© 2019 DeFelsko Corporation USA All Rights Reserved
9