Returning For Service - DeFelsko PosiTector RTR Guide De Démarrage Rapide

Before returning the Gage for service...
1.Install new or newly recharged batteries in the proper alignment
as shown within battery compartment.
2.Clean the measurement opening using the cleaning card (pg 5).
3.Perform a Hard Reset (pg. 8).
4.Measure the check shim to verify accuracy (pg. 5).
If you must return the Gage for service, describe the problem fully
and include measurement results, if any. Be sure to also include
the probe, your company name, company contact, telephone
number and fax number or email address.
Website: www.defelsko.com/support
Limited Warranty, Sole Remedy
Limited Warranty, Sole Remedy
DeFelsko's sole warranty, remedy, and liability are the express
limited warranty, remedy, and limited liability that are set forth on
its website: www.defelsko.com/terms
This manual is copyrighted with all rights reserved and may not be reproduced or transmitted, in whole or
part, by any means, without written permission from DeFelsko Corporation.
DeFelsko and PosiTector are trademarks of DeFelsko Corporation registered in the U.S. and in other
countries. Other brand or product names are trademarks or registered trademarks of their respective hold-
ers.
Every effort has been made to ensure that the information in this manual is accurate. DeFelsko is not
responsible for printing or clerical errors.

Returning for Service

Returning for Service
and Limited Liability
and Limited Liability
www.defelsko.com
© DeFelsko Corporation USA 2013
All Rights Reserved
12