Preparing The Fabric And Straps - SOMFY HiPro-FTS 50 Notice D'installation

8. Preparing the fabric and straps

1. Press the end limit setting
push buttons on both
actuators, to put them into the
setting position (push buttons
engaged).
2. Attach and wind the fabric
onto its roller tube (using
setting tool ref.: 9137080).
Black
roller
Brown
roller
Note: The «dynamic tension»
wire must be insulated with an
electrical split fitting.
3. Mount the pulleys and straps,
making sure that they are
perpendicular to the roller
tubes.
Mount the load bar on its
guidance system to prevent
the fabric from sagging too
much during the subsequent
manoeuvres.
4. Wind the straps between the
pulleys, using the setting tool
ref.: 9137080.
Black
"fabric"
roller
Brown
"fabric"
roller
Black
"straps"
roller
Brown
"straps"
roller
Note: The "dynamic tension" wires must
be insulated with electrical split fittings.
Copyright © 2013 - 2017 Somfy SAS. All rights reserved.
5034918A_FTS.indb 7
PUSH BUTTON IN SETTING POSITION
Indicated colors :
«europe» range
y / G
ELLOw REEN
N
b
LUE
▲
R (b b
OLLER LACk OR ROwN
▼
G (b )
REy RAkE
y / G
ELLOw REEN
N
b
LUE
▲
R (b b
OLLER LACk OR ROwN
▼
G (b )
REy RAkE
Europe /
Comments
China
Blue Shared
Black Yellow push button
Brown White push button
Grey Brake
Y/G Earth
1 2 3 4
N
D (
yNAmIC TENSION bROwN OR bLACk
1 2 3 4
N
)
D (
yNAmIC TENSIONS bROwN OR bLACk
1 2 3 4
N
)
1 2 3 4
N
y / G
ELLOw
N
b
LUE
▲
R (b
OLLER
▼
G (b
REy RAkE
BP JAUNE BP BLANC
BP BLANC
)
)
REEN
b )
LACk OR ROwN
)
7
09/05/2017 15:08:28
BP JAU