Liability; Installation; Assembly; Preparing The Tube - SOMFY Sonesse 40 io Notice D'utilisation

EN

1.2. LIABILITY

Please read these instructions carefully before installing and using the drive. In addition to following the instructions
given in this guide, the instructions provided in the attached Safety instructions document must also be observed.
The drive must be installed by a drive and home automation professional, in accordance with Somfy's
instructions and the regulations applicable in the country of installation.
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to
comply with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of
any liability and invalidates the warranty.
The installer must inform its customers of the operating and maintenance conditions for the drive and must provide them
with the operating and maintenance instructions, and the attached Safety instructions document, a er installing the
drive. Any A er-Sales Service operation on the drive must be performed by a drive and home automation professional.
Should any doubt arise during installation of the drive or for additional information, consult a Somfy contact or visit
www.somfy.com.

2. INSTALLATION

Warning
• These instructions are mandatory for the drive and home automation professional installing the drive.
• Comply with current standards and legislation in the country of installation.
Attention
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
• To ensure optimised silent operation, the gaps between the drive, the accessories, the tube and the tube
end piece must be minimised.

2.1. ASSEMBLY

2.1.1. Preparing the drive
Check that the inner diameter of the motorised product's tube is greater
than 37 mm.
1) Fit the accessories required to integrate the drive into the winding
tube:
Fit the crown (a) and drive wheel (b) to the drive.
-
2) Measure the length (L) between the inner edge of the drive head and
the rim of the drive wheel.

2.1.2. Preparing the tube

1) Cut the winding tube to the required length, depending on the
motorised product.
2) Deburr the winding tube and remove the swarf.
3) For winding tubes which are smooth inside, cut a notch with the
following measurements: l = 7 mm, L = 10 mm.
10
1)
a
2)
1)
3)
©
Copyright 2018 SOMFY ACTIVITES SA, Société Anonyme. All rights reserved.
Sonesse 40 io
b
L = ...
L
2)
Ø > 37
l
L