Care, Maintenance And Disposal; General Remarks; Every Start-Up; Every 2 Months - Fronius TransPocket 2500 Instructions De Service

Care, maintenance and disposal

Under normal operating conditions the power source requires only a minimum of care

General remarks

and maintenance. However, it is vital to observe some important points to ensure the
welding machine remains in a usable condition for many years.

Every start-up

-
-

Every 2 months

-

Every 6 months

-
-

Disposal

Dispose of in accordance with the applicable national and local regulations.
WARNING! An electric shock can be fatal. Before opening up the machine
- Move the mains switch to the „O" position
- Unplug machine from the mains
- Put up an easy-to-understand warning sign to stop anybody inadvertently
switching it back on again
- Using a suitable measuring instrument, check to make sure that electri-
cally charged components (e.g. capacitors) have been discharged
Check mains plug, mains cable, welding torch, interconnecting hosepack and
grounding (earthing) connection for damage
Check whether the allround distance of 0.5 m (1ft 8in.) is kept to ensure that the
cooling air can easily flow and escape.
NOTE: Air inlets and outlets must never be covered, not even partially.
Clean air filter
Dismantle machine side panels and clean machine inside with dry reduced com-
pressed air
NOTE: Risk of damage to electronic components. Do not bring the air nozzle
too close to the electronic components.
If a lot of dust has accumulated, clean the cooling-air ducts.
21