Controls And Connections; Safety; Connections - Fronius TransPocket 2500 Instructions De Service

Controls and connections

Safety

Connections

Fig. 2 Controls and connections on the front and back of the machine
(1) Mains switch
(2) Shielding gas connection socket (only on TP 2500 TIG) ... for connecting the gas
(3) Dust filter ... where the fan draws in air
(4) (+) Current socket with bayonet latch ... for connecting the
(5) (-) Current socket with bayonet latch ... for connecting the
(6) Remote control unit connection socket... for connecting
WARNING! Operating the equipment incorrectly can cause serious injury and
damage. You should not use the functions described until you have thoroughly
read and understood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety regulations
(4)
(6)
hose
- Prevents contamination of the housing interior if a lot of dust has accumulated
NOTE! The manufacturer strongly recommends that a dust filter be used with
the power source.
- rod electrode or grounding/earthing cable in rod electrode (MMA) welding,
depending on the type of electrode being used
- the grounding (earthing) cable when TIG welding
- rod electrode or grounding/earthing cable in rod electrode (MMA) welding,
depending on the type of electrode being used
- Welding torch in TIG welding (current connection)
- a remote control unit
(2)
(5)
4
(1)
(3)