Setting Up The Sirius Multigas Detector; Changing Instrument Settings; Accessing The Instrument Setup Mode - MSA SIRIUS Manuel D'instructions

5

Setting up the SIRIUS Multigas Detector

5. Setting up the SIRIUS Multigas Detector

5.1 Changing Instrument Settings

• Many options can be set using the instrument buttons.
• If the SIRIUS Multigas Detector was ordered with the optional datalogging, the
MSA LINK software can be used to set most of the instrument selections, including
some that cannot be changed from the instrument's front panel buttons.

5.2 Accessing the Instrument Setup Mode

• Press and hold the RESET/
displays.
NOTE:
In all of the following selections in this Set-up mode:
• Press ON/OFF to enter chosen value/go to the next page.
• Press the ON/OFF button to store the chosen value.
• Press RESET/
• Press and hold RESET/
• Press PAGE/
• Press and hold PAGE/
• Enter password default "672".
• Press ON/OFF to enter password.
• Correct Password: instrument continues/beeps three times.
• Incorrect Password: instrument enters the Measure mode.
• Password ON/OFF (turns the password protection ON or OFF)
• New Password Setup (changes the password)
28
button while turning the instrument ON. SETUP
to decrement by one or toggle ON/OFF.
to decrement by 10.
to increment by one or toggle ON/OFF.
to increment by 10.