Operating The Optional 3-Stage Permanently Attached I.v. Pole - Stryker M Série Mode D'emploi

OPERATING THE OPTIONAL 3-STAGE PERMANENTLY ATTACHED I.V. POLE

C
B
D
A
E
Figure 12 - I.V. Pole
Note
The 3-stage permanently attached I . V . pole is an option and may have been installed at either the head, foot or both ends
of the stretcher . The choice was made at the time the stretcher was purchased .
To use the 3-stage permanently attached I . V . pole:
1 . Lift and pivot the pole from the storage position and push down until it is locked into the receptacle .
2 . To raise the height of the pole, pull up on the telescoping portion (A) until it locks into place at its fully raised
position .
3 . For a higher I . V . pole, pull up on section (B) . Release section (B) at any desired height and it will lock into place .
4 . Rotate the I . V . hangers (C) to the desired position and hang the I . V . bags .
5 . To lower the I . V . pole, push up on the red portion of grip (D) while holding onto section (B) until it lowers . Turn latch
(E) until section (A) lowers .
CAUTION
To avoid damage, the weight of the I . V . bags should not exceed 40 pounds .
www.stryker.com
Stretcher Operation
Figure 13 - Detail of I.V. Pole Latch
1025-009-005 REV B
A
E
Figure 14 - Detail of I.V. Pole Grip
Return To Table of Contents
C
B
D
1-19