Speed Limitation Of The Drive; Tool Replacement - Heidolph SilentCrusher M Mode D'emploi

To disconnect the device from the power supply system, unplug the mains plug.
When operating under pressure or in a vacuum, always position the stator shaft
with the sealed tool in the fluid so that the upper hole (TT) in the stator shaft is
always above the level of the fluid.
If the hole (TT) is below the level of the fluid, it can enter the upper range of the
dispersion tool and damage it.
Please note minimum and
maximum immersion
depth!

9.1 Speed limitation of the drive

The tools 22 F and 22 G can be operated with a maximum speed of 20,000 rpm. If this speed is
exceeded, the drive automatically limits the speed after a brief period.
The limitation to 20,000 rpm is portrayed by the blinking right decimal point on the display (DD)
and can be reset by reducing the desired speed <20,000 rpm.
With an appropriate load, speed limitation can also activate with tools <22 F/G.

10. Tool Replacement

Always disconnect the device using the switch (Y) before replacing the tool.
Standard Dispersion Tool (1)
* minimal immersion
depth using vacuum
Min.
8DF
12DF
12DG
18DF
18DG
- 39 -
Min. (vac)* Max.
25 35
25 35
25 35
25 35
25 35
Min.
6F 20
8F 25
12F 25
12G 25
18F 25
18G 25
22F 30
22G 30
E
E
50
75
75
135
135
Max.
50
55
80
80
140
140
140
140