Section 5 − Installation; Installing Control Box And Adjusting Tilt - Miller D-74S Manuel D'utilisation

5-1. Installing Control Box And Adjusting Tilt

4
3
Tools Needed:
3/8 in.
Notes
OM-252717 Page 14
SECTION 5 − INSTALLATION
1
2
1 Weld Control
2 Bracket
3 Screw
Bracket and screws are installed
onto bottom of control at factory.
4 Swivel
Loosen screws. Place control on
swivel and slide forward. Tighten
screws.
5 Tilt Bracket
6 Rear Pivot Screw
7 Front Screw
Loosen rear pivot screw. Remove
5
front screw. Pivot control down-
ward to desired viewing angle. Re-
place and tighten front screw. Tight-
6
en pivot screw.
7
803182-B