Minimum Clearance To Combustible Enclosures - Napoleon Luxuria Serie Manuel D'installation

5.1.1 minimum clearance to combustible enclosures

single-sided
1" [25mm] minimum all sides for
sections of vertical venting.
When passing through a ceiling,
use fi restop spacer W500-0028
(not supplied)
0" to side standoffs
1/2" fi nishing fl ange
0" to bottom of the
appliance
Horizontal vent sections: A minimum clearance of 3" (76mm) on the top outside of the enclosure and 2" (51mm) on
the sides and bottom outside of the enclosure all around the vent pipe on all horizontal runs to combustibles is required.
Horizontal vent sections within enclosures require a minimum clearance of 6"(152mm) at the top of the vent pipe.
Vertical vent sections: A minimum of 1" (25mm) all around the vent pipe on all vertical runs to combustibles is required
except for clearances in appliances enclosures. Vertical vent sections within enclosures require a minimum clearance of
1" (25mm) around the vent pipe.
note:
The LVX series requires a minimum enclosure height, as illustrated (dimension L), measured from the bottom of the appli-
ance. For temperature requirements, this area must be left unobstructed. Some venting confi gurations that require more
vertical rise will require a larger enclosure to provide minimum vertical clearance between vent pipes and combustibles.
minimum clearance
rough framing - before appliance installation
L
Ref LVX38-1
L 73" (185.4cm)
6" [152mm] minimum
(inside enclosure)
0" to back standoffs
LVX50-1 LVX62-1
91" (231.1cm)
EN
3" [76mm] to top
(outside of enclosure)
2" [51mm] to sides /
bottom
(outside of enclosure)
When passing through
a wall, use fi restop
spacer assembly
W010-4178 (supplied)
0" to non-combustible
fi nishing such as brick
and stone. When using
non-combustible fi nish-
ing, only use fi restop
spacer (W615-0162)
included in the fi restop
assembly (W010-4178)
LVX74-1
35
W415-2035 / C / 04.30.21