Air Shutter Adjustment; Restricting Vertical Vents; Venturi Adjustment - Napoleon Luxuria Serie Manuel D'installation

adjustments
13.0 adjustments
EN

13.1 restricting vertical vents

Vertical installations may display a very active fl ame. If this appearance is not desirable, the vent exit in the
appliance must be restricted using a restrictor vent kit. Refer to the "replacement parts" section of the owner's
manual for the appropriate kit. This will reduce the velocity of the exhaust gases, slowing down the fl ame pattern
and creating a more traditional gentle fl ame appearance. Specifi c instructions are included with the kit.

13.2 venturi adjustment

This appliance is equipped with an externally adjustable air shutter that is not preset from factory. Any
adjustments made to the shutter must be done with door installed, including the burner and all media installed
into the appliance. It is important to operate the appliance and verify that the air shutter is opened to the
correct amount to prevent either fl ame lifting or carbonizing and to optimize the appearance of the fl ame.
To open or close the shutter, pull the rod away from the appliance or push the rod towards the appliance
respectively.
Small adjustments on the shutter can have a drastic effect on the fl ame appearance; it is recommended to
adjust the shutter in 1/8" increments.
WARNING
!
• Air shutter adjustment must be done by a qualifi ed installer
Regardless of air shutter location closing the air shutter will cause a more yellow fl ame, but can lead to
carbonization. Opening the air shutter will cause a more blue fl ame, but can cause fl ame lifting from the
burner ports. The fl ame may not appear yellow immediately, allow 15 to 30 minutes for the fl ame colour to
be established.
78
W415-2035 / C / 04.30.21
Air Shutter
Adjustment
OPEN
CLOSE