Dynamic Heat Control - Napoleon Luxuria Serie Manuel D'installation

Masquer les pouces Voir aussi pour Luxuria Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.4

Dynamic Heat Control™

PATENT PENDING
Installer:
Ability to use combustible framing and fi nishing right up to the fi replace opening.
High temperatures above the front of the fi replace opening are signifi cantly reduced eliminating potential de-
grading to sensitive fi nish material (cracks or discoloration).
No additional electricals, fans, ducts, or manifolds are required which keeps installation straightforward.
User:
Heat is circulated more consistently throughout the living space increasing comfort in front of the fi replace.
Increased "real world" effi ciency as heat is moved in to the room rather than retained inside an enclosure.
Complete fl exibility in selection of fi nish materials.
Ability to place a TV, sound bar or artwork above the fi replace.**
The Dynamic Heat Control™ system relies on an optimized fl ow of air both through the appliance and the en-
closure. As such the installation of the Dynamic Heat Control™ system requires certain technical considerations
when compared to traditional fi replaces. Specifi cally, the Dynamic Heat Control™ requires the enclosure to be
ventilated and requires the installer to ensure that a minimum opening area is provided to allow heat to escape
and circulate at a prescribed minimum height and position. This must be carefully adhered to in the planning and
the installation to ensure the appliance functions safely and to minimize installation time.
*In most common installation confi gurations, some specifi c installations require special provisions.
See "framing with Dynamic Heat Control™ section for details. Ensure to strictly adhere to instructions.
** Always check the appliance manufacturer's recommendations to confi rm suitability and any special
environmental limitations. For valuable or antique items, always refer to expert preservation instruc-
tions as some items require specifi cally controlled temperature and/or humidity
general information
Dynamic Heat Control™ is a system for managing the
heat produced by the appliance at and around the fi re-
place. The purpose of the Dynamic Heat Control™ is
to move the heat away from the fi replace to allow it to cir-
culate more effectively within the living space. By install-
ing the Dynamic Heat Control™ both the installer and
the user gain considerable benefi ts, see the following;
*
W415-2035 / C / 04.30.21
EN
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières