Napoleon Luxuria Serie Manuel D'installation page 37

Before framing your appliance, determine vent requirements before deciding the fi nal location of the appliance.
After rough framing, place the appliance in its fi nal position.
single-sided
L
J
Ref LVX38-1
E*
F 53 13/16" (136.7cm)
J
L
see-thru
Ref LVX38-1
E*
F 53 13/16" (136.7cm)
J
L
rough framing - before appliance installation
E
F
LVX50-1
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
73" (185.4cm)
Before framing the appliance, ensure to install
the fi restop fi rst as it will not fi t between the
studs if installed after framing.
L
E
F
J
LVX50-1
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above fl oor
73" (185.4cm)
Before framing the appliance, ensure to install
the fi restop fi rst.
note:
The LVX series requires a
minimum enclosure height, as
illustrated (dimension L), mea-
sured from the bottom of the
appliance. For temperature
requirements, this area must be
left unobstructed. Some venting
confi gurations that require more
vertical rise will require a larger
enclosure to provide minimum
vertical clearance between vent
pipes and combustibles.
LVX62-1
18" (45.7cm)
77 13/16" (197.6cm)
note:
The LVX series requires a minimum enclosure
height, as illustrated (dimension L), measured
from the bottom of the appliance. For tem-
perature requirements, this area must be left
unobstructed. Some venting confi gurations that
require more vertical rise will require a larger en-
closure to provide minimum vertical clearance
between vent pipes and combustibles.
LVX62-1
16 3/16" (41.1cm)
77 13/16" (197.6cm)
LVX74-1
89 13/16" (228.1cm)
91" (231.1cm)
*Maximum of 21" (53.5cm)
LVX74-1
89 13/16" (228.1cm)
91" (231.1cm)
*Maximum of 21" (53.5cm)
W415-2035 / C / 04.30.21
EN
37