Rating Plate/Lighting Instruction Location - Napoleon Luxuria Serie Manuel D'installation

Masquer les pouces Voir aussi pour Luxuria Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

1.5

rating plate/lighting instruction location

Both the rating plate and lighting instructions are attached to a chain located on the left side of the control
area near the valve (access side). Remove the glass guard and the control cover to gain access to the
control area.
To replace, slide the instructions back into the control area and slide the glass front into its locked position.
access side
Rating plate
location
Certified to Canadian and American National Standards: CSA 2.22-XXXX / ANSI Z21.50-XXXX for Vented Decorative Gas Appliances
Certifié selon les normes Nationales Canadiennes et Américaines: CSA 2.22-XXXX / ANSI Z21.50-XXXX pour les Appareils à gaz décoratif à évacuation
Direct vent, vented gas fireplaces. Approved for bedroom, bathroom and bed-sitting room installation. Suitable for mobile home installation, if installed in accordance with the current
standard CAN / CSA Z240MH Series gas equipped mobile homes in Canada, or, in the United States, the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part
3280. When this US Standard is not applicable, use the Standard for Fire Safety Criteria for Manufactured Home Installations, Sites and Communities, ANSI / NFPA 501A. This appliance
must be installed in accordance with local codes, if any; if none, follow the current ANSI Z223.1 or CSA B149. For use with barrier WXXX-XXXX. Follow installation instructions.
Foyer à gaz ventilé. Homologué pour installation dans une chambre à coucher, une salle de bain et un studio. Approprié pour installation dans une maison mobile si son installation
conforme aux exigences de la norme CAN / CSA Z240MH Séries de maisons mobile équipées au gaz en vigueur au Canada, ou, aux États-Unis selon la norme 24 CFR, Part 3280,
Manufactured Home Construction and Safety Standard. Dans le cas ou cette norme d'États-Unis n'est pas pertinentes, utiliser la norme NFPA 501A, Fire Safety Criteria for Manufactured
Home Installations, Sites and Communities. Installer l'appareil selon les codes ou règlements locaux ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1 ou
CSA B149 en vigueur. Utiliser uniquement avec l'écran WXXX-XXXX. Suivre les instructions d'installation.
9700539 (WSL)
XXXX
XXXX
Altitude
Input
Reduced Input
P4
Manifold Pressure: 3.5" w.c. (NG)
Minimum Supply Pressure: 4.5" w.c. (NG)
Maximum Supply Pressure: 7"* w.c. (NG)
Pression au Collecteur: 3,5" d'une colonne d'eau (GN)
Pression d'Alimentation Min.: 4,5" d'une colonne d'eau (GN)
Pression d'Alimentation Max.: 7" ** d'une colonne d'eau (GN)
** Maximum inlet pressure not to exceed 13".
Minimum clearance to combustible materials:
Top, sides & back: per standoff spacers for framing and finishing
materials. For non-combustible framing and finishing materials,
see installation manual.
Top X"
Floor X"
Sides X"
Back X"
Vent top X"
Vent sides & bottom X"
Recessed depth X"
*** Mantel X" from appliance opening
*** Maximum horizontal extension:
X". See installation manual for
greater extensions, minimum vent
lengths and maximum vent lengths.
Electrical rating: 115V, 60HZ. Less than 12 amperes.
WOLF STEEL LTD.
This illustration is for reference only. Refer to the rating plate on the appliance for accurate information.
note:
The rating plate must remain with the appliance at all times. It must not be removed.
4001658 (NAC)
4001657 (NGZ)
4001659 (WUSA)
MODEL / MODÈLE
XXXX
XXXX
XXXX
XXXX
XXXX
XXXX
0-XXXXft (0-XXXXm)
XX,XXX
XX,XXX
XX,XXX
XX,XXX
Alimentation Réduite
XX.X%
XX.X%
Manifold Pressure: 10" w.c. (P)
Minimum Supply Pressure: 11" w.c. (P)
Maximum Supply Pressure: 13"* w.c. (P)
Pression au Collecteur: 10" d'une colonne d'eau (P)
Pression d'Alimentation Min.: 11" d'une colonne d'eau (P)
Pression d'Alimentation Max.: 13" * d'une colonne d'eau (P)
** Pression d'alimentation maximale ne devait pas dépasser 13".
Dégagements minimaux des matériaux combustibles:
Dessus, côtés et arrière: selon les espaceurs de dégagements
pour les matériaux d'ossature selon le manuel du propriétaire
pour les matériaux de finition.
Dessus du conduit d'évent X"
Côtés et dessous du conduit d'évent X"
Profondeur d'encastré une face X"
*** Tablette X" de l'ouverture de l'appareil
*** L'extension horizontale maximale: X".
Référez au manuel d'installation pour des
extensions plus grandes, les longueurs
d'évacuation minimaux et maximum.
Spécifications électriques: 115V, 60HZ. Moins de 12 ampère.
24 Napoleon Road, Barrie, ON, L4M 0G8 Canada
general information
Pilot location
VENTED DECORATIVE GAS APPLIANCE: NOT A SOURCE OF
HEAT, NOT INTENDED FOR USE AS A HEATING
APPLIANCE, NOT FOR USE WITH SOLID FUEL.
APPAREIL À GAZ DÉCORATIF À ÉVACUATION: N'EST PAS
Élévation
UNE SOURCE DE CHALEUR; N'EST PAS DESTINÉ À ÈTRE
Alimentation
UTILISÉ COMME UN APPAREIL DE CHAUFFAGE; NE
P4
CONVIENT PAS AUX COMBUSTIBLES SOLIDES.
FOR USE WITH GLASS DOORS CERTIFIED WITH THIS APPLIANCE ONLY.
POUR UTILISATION UNIQUEMENT AVEC LES PORTES EN VERRE
For natural gas when equipped with No. XX drill size orifice.
For propane when equipped with No. XX drill size orifice.
Convient au gaz naturel quand l'appareil est muni d'un injecteur de diamètre no. XX.
Convient au propane quand l'appareil est muni d'un injecteur de diamètre no. XX.
WARNING
:
Do not add any material to the appliance which will come in contact with the
flames, other than that supplied by the manufacturer with the appliance.
Dessus X"
AVERTISSEMENT
Plancher X"
:
N'ajoutez pas à cet appareil aucun matériau devant entretien
Côtés X"
contact avec les flammes autre que celui qui est fourni avec cet appareil par le fabricant.
Arrière X"
The appliance must be vented using the appropriate Napoleon vent kits. See installation
manual for venting specifications. Proper reinstallation and resealing is necessary after servicing
L'appareil doit être ventilé à l'aide de l'ensemble d'évacuation propre à Napoleon. Référez au
manuel d'installation pour les spécifications d'évacuation. Il est nécessaire de bien réinstaller et
resceller l'évacuation après avoir executer l'entretien du système de prise d'air.
XXXX
Serial Number / N° de Série:
REFERENCE# 161746
CERTIFIÉES AVEC L'APPAREIL.
the vent-air intake system.
W385-XXXX
W415-2035 / C / 04.30.21
EN
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières