Maintenance Schedule; Servicing The Vacuum Motor; Important; Lubricating The Machine - Advance SC900 ST Série Mode D'emploi

MAINTENANCE SCHEDULE

Empty/Clean Debris Catch Tray in Recovery Tank
Check Each Battery Cell(s) Water Level
Have an Authorized Advance Service Center check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The
*
brush and drive motor carbon brushes should be checked every 500 hours or once a year.
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.

SERVICING THE VACUUM MOTOR

Have your Advance Dealer check the carbon motor brushes once a year or after 300 operating hours.

IMPORTANT!

Mot or damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited Warranty
Statement.

LUBRICATING THE MACHINE

Once a month, apply light machine oil to lubricate the:
• General Pivot Points for the Squeegee Linkage (A).
• Squeegee Tool end wheels (B).
• Scrub deck bumper wheel (C).
• General Pivot Points for the Brush Linkage (D).
Once per quarter, Grease the following
• Rear Caster Wheel Swivels (E).
11/2015
MAINTENANCE ITEM
Charge Batteries
Check/Clean Tanks & Hoses
Check/Clean the Brushes/Pads
Check/Clean the Squeegee
Check/Clean Vacuum Shut-Off Float
Inspect Scrub Housing Skirt
Inspect and clean Solution Filter
Purge Detergent System
Lubrication of Machine
* Check Carbon Brushes
D
INSTRUCTIONS FOR USE
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
C
D
A
E
B
56091183 - SC900 ST
ENGLISH - A
Yearly
X
X
B
A - 19