Commissioning; Identifying Setting Steps Already Completed; Pre-Programming The Somfy Io Local Control Point - SOMFY HOME MOTION J4 io Notice Installateur

5. COMMISSIONING

The guide only describes commissioning using a Situo mobile io VB type Somfy io local control point
which provides greater precision when tilting the slats.
For commissioning using any other io control point, refer to the corresponding guide.

5.1. Identifying setting steps already completed

Only one motor should be powered at a time.
Switch on and follow procedure "a" or "b"
depending on the reaction of the blind:
a) The blind moves briefly
The end limits are set and no
Somfy control point has been stored.
Go to the section entitled 5.5 "Programming the first
Somfy io local control point".
or
b) The blind does not move
Press the Up or Down buttons and follow
procedure "c" or "d" depending on the reaction of the
blind:
c) The blind still does not move
The end limits are not set and no
Somfy control point has been stored.
Go to the section entitled 5.2 "Pre-programming the
Somfy io local control point".
or
d) The blind is fully raised or lowered
The end limits are set and the
Somfy control point has been stored.
Go to the section entitled "Operation".

5.2. Pre-programming the Somfy io local control point

• Press the Up and Down buttons simultaneously.
The blind moves briefly, the Somfy local
io control point is pre-programmed to the motor.
64
© 2011 Somfy SAS. All rights reserved. 11/2011
Programming the first
Somfy local control
point
c d
or
Pre-programming the
Somfy io local control
point
Operation