Operator Modes; Selection Of The Operator Mode - Burkert MKEN-1094 Instructions De Service

6.3

Operator Modes

There are six operator modes, that differ by the extent of their functions::
• Flow Meter
The unit is used as independent flow meter. Only the gas meter has to be
connected.
• PRTother (Version C)
The unit is used to control the vapor recovery. Only the gas meter has to be
connected. A protocol can be printed.
NOTE
• Check-1094
Control functions for vapor recovery are possible.
• Service
All the required setting and control operations can be carried out.
• Evaluation
Additional data is displayed.
• PRT-1094 (Version C)
The unit is used to control the vapor recovery. A protocol can be printed.
6.4

Selection of the Operator Mode

Switching on the hand held terminal
Selecting the operator mode
Confirmation
NOTE
56
The following operating modes require the connection to a
control electronics, compatible to the BUERKERT-device type
1094.
Without the connection of of a control electronics only the
operator modes "Flow meter" and "PRTother" are possible.
ENTER
MKEN-1094 Version A and C