Logging On And Logging Off Handsets; Logging On D6020 Handsets; Logging On Other Dect-Gap Telephones To The Base Station - switel D6020 Mode D'emploi

9.3

Logging on and logging off handsets

9.3.1

Logging on D6020 handsets

1. Press and hold the page button
until you hear two signal tones. Now log on the new handset to the base
station within 90 seconds.
2. Press the
3. Select the REGISTER menu with
4. Select the REG BASE menu with
5. Now enter the number of the base station (1 - 4) using the number pad. If
the handset is already connected to a base station, the corresponding
numbers will flash.
6. Confirm your entry with the
the base station.
7. After the base station has been found, you must enter the PIN Code for
the base station (factory setting 0 0 0 0).
8. Confirm your entry with the
hear a signal tone. The handset is now logged on and can be used for
external and internal calls.
9. An internal number will now be automatically assigned to the handset.
The handset that has already been logged on has the internal number 1.
The second handset to be logged on is given the internal number 2.
These internal numbers are shown in the right of the display next to the
name.
9.3.2

Logging on other DECT-GAP telephones to the base station

In order to log on a DECT-GAP handset, follow the instructions in the other
supplier's operating manual and then press the
for 6 seconds. Use the PIN-Code 0 0 0 0 to log on.
- Multiple handsets -
button on the handset.
on the base station for 6 seconds
and and confirm with
and and confirm with
button. A search will now be carried out for
button and after a few seconds you will
button on the base station
.
.
159