Setting Up; Check Contents Of Pack; Connecting The Base Station; Fitting Standard Batteries - switel D6020 Mode D'emploi

3

Setting up

3.1 Safety information
NOTE: Before setting up, it is essential that you read the Safety Information at
the beginning of this operating manual.
3.2

Check contents of pack

The following items are supplied:
one base station
one handset with belt clip
one telephone connecting cable
3.3

Connecting the base station

Position the telephone near to your telephone connection socket and to a mains
socket.
1. Insert the plug of the power supply into the socket on the underside of the
base station and plug the power supply into a properly installed 230 V
mains socket. The plug-in power supply for the base station must always be
connected. For safety reasons, use only the plug-in mains power supply
provided.
2. Connect the telephone cable supplied to the telephone socket and the
telephone jack on the underside of the base station. Use only the new
telephone cable provided.
3. Run the two cables through the two cable channels to the rear of the base
station.
3.4

Fitting standard batteries

To fit the standard rechargeable batteries supplied into the
handset, press on the upper edge of the battery
compartment and slide it downwards. Now insert the
batteries taking care to ensure that the polarity is correct.
Close the battery compartment cover.
130
- Setting up -
one mains cable
two standard batteries
one instruction manual
+