Locomotive Settings - Roco 85 Serie Manuel

▪ Locomotive Settings

The Sounddecoder has been optimally adjusted to this locomotive. You can still adapt numerous
decoder properties to your wishes however. Certain parameters (referred to as CVs – Configu-
ration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in
the decoder not reacting correctly.
The decoder is preprogrammed with 128/28 speed steps at the factory for a high level of com-
fort. This means that it can be used together with all of the modern DCC (MULTIMAUS®) and
Motorola control devices.
®
The Sounddecoder has been especially modified for the additional functions and must
not be replaced with a decoder which is available from a retailer.
If the locomotive is to be reprogrammed, only the locomotive is to be on the program-
ming track.
▪ CV-Liste of the BR 85
CV Name
1 Address (= short address)
2 Minimum speed (lowest creeping speed)
3 Start-up delay (from standstill to maximum speed)
4 Braking delay (from maximum speed to stand-still)
5 Maximum speed
6 Medium speed (at medium running step)
Value 1 corresponds to 1/3 of Vmax. (CV 5)
7 Decoder Version Number (only read! Readable only on
reading-capable amplifiers/centres).
Important! Please note when using the MULTIMAUS®
in order to achieve CVs greater than CV255: when un-
dertaking a short-term programming of CV7, only the
subsequent programming access with the value 10 is
increased by 100 CV places (meaning CV166 then ac-
cesses CV266 for example). The value 20 is increased
by 200 CV places.
8 Resetting of all values to the default settings; (With
readable amplifiers/controllers, the manufacturer ID is
readable)
8072264920 - neue mit Fehlerbehebung.indd 27
Value Default
Value
01 – 99 3
01 – 252 1
00 – 255 48
00 – 255 24
00 – 252 120
00 – 252 1
08 = Reset
22.05.2018 13:28:18
27
27