Table Des Matières; Safety Measures; Starting The Pump; Automatic Operation - DAB NOVAPOND Instructions De Mise En Service Et D'entretien

INDEX
1. SAFETY MEASURES ........................................................................................................................................................................................... 3
2. USE ....................................................................................................................................................................................................................... 3
3. STARTING THE PUMP ......................................................................................................................................................................................... 3
4. RECOMMENDATIONS ......................................................................................................................................................................................... 4
5. TROUBLESHOOTING .......................................................................................................................................................................................... 4
6. DISPOSAL ............................................................................................................................................................................................................ 4
7. GUARANTEE ........................................................................................................................................................................................................ 4

1. SAFETY MEASURES

Before starting the pump, read this instruction booklet carefully.
When handling the pump, while it is connected to the electric power supply, you should avoid all contact with water..
Before taking any action on the pump, always remove the plug from the power socket.
Overload protection
The pump has a thermal overload safety device. In the event of any overheating of the motor, this device automatically switches off
the pump. The cooling time is roughly 15 to 20 minutes, then the pump automatically comes on again. If the overload cutout is tripped, it is
essential to identify and deal with the cause of the overheating. See Troubleshooting.
2. USE
Submersible pumps for garden ponds to create water falls and fountains (NOVAPOND). The pumps are designed to pump clean water or
water containing solids with a diameter from 5 to 10 mm (depending on the regulation of the filter).
Ideal for continuous use
•
Designed for horizontal or vertical installation.
•
Multi-impeller submersible pumps with 2, 3 or 4 impellers (DIVER 6): ideal for rain water and mains irrigation systems, for pumping water
from tanks, ponds and wells and other applications that require high pressure. The multistage submersible pumps must only be used in clean
water. The pump should ideally be completely submersed for it to operate correctly, but can be used at a minimum suction height of 50 mm for
very short periods.
Available in an automatic version with float switch for automatic starting and stopping of the pump.
Characteristics:
Optimum motor cooling that allows the pump to be used also when it is only partially submersed.
•
Stainless steel anti-deposit filter
•
Non-return valve and 4-way connector.
•
Multipurpose submersible pumps designed specifi cally for use in salt water. (NOVA SALT W). Equipped with:
anti-oxidation and anti-corrosion materials
•
AISI 316 stainless steel motor casing, drive shaft and bolts.
•
The temperature of the fluid being pumped must never exceed 35° C.
The pump must not be used to pump salt water (unless specifically designed for the purpose), sewage (except for
submersible pumps suitable for pumping dirty water with solid particles having a maximum diameter of 38 mm), flammable,
corrosive or explosive liquids (e.g. petroleum oil, petrol, thinners), grease, oils or foodstuffs.
Comply with the rules and regulations of the local water authority when using the pump for the supply of domestic water.

3. STARTING THE PUMP

Before starting the pump, make sure that:
There are no signs of damage to the pump or its power cord;.
•
Any extension cords must comply with the requirements of the DIN VDE standard 0620.
•
Note: given the different provisions applicable to the safety of electric systems in different countries, make sure that the pump system, as concerns
its intended use, is in accordance with current legislation.
Insert the plug of the power cable into a suitable power socket.

Automatic operation:

The floating switch starts and stops the pump automatically.
The water level that prompts the starting and stopping of the pump can be adjusted by changing the length of
cable of the float between the holder and the float.
N.B. The length of the float cable must never be shorter than 10 cm.

Manual operation:

a) The floating switch must be lifted in order to start pumps with a float.
ENGLISH
3