EN
6. When only the green operating lamp is still lit, the battery is fully charged.
7. First disconnect the mains adapter from the mains power and then disconnect the
barrel connector from the charging station.
8. Press the release button on the battery and pull the battery out of the charging station.
9. Insert the battery into the device. The battery must be heard to engage in place.
Assembly
PLEASE NOTE!
■
Always switch off the device before replacing any accessories.
Attaching / Removing the Electrical Floor Nozzle and Extension Tube
No nozzle adapter (14) is required for the electrical fl oor nozzle (9) and the extension
tube (11).
•
Attaching: Put the extension tube directly onto the suction opening (8). The catch
must be heard to engage in place. Attach the electrical fl oor nozzle to the extension
tube in the same way.
The electrical fl oor nozzle can not be directly attached to the suction opening.
Attaching / Removing Nozzles
With the exception of the electrical fl oor nozzle (9), all nozzles are attached with the aid
of the nozzle adapter (14).
•
Attaching: Plug the nozzle adapter into the suction opening (8) or the extension
tube (11). Plug the nozzle you want onto the nozzle adapter.
•
Detaching: Pull the nozzle and nozzle adapter out of the suction opening or the
extension tube.
Removing / Inserting the Dust Container
closed
open
22
•
Removing: Untwist the dust container (7) clockwise. This
releases it from the motor unit (3) and it can be removed.
•
Inserting: Insert the dust container into the motor unit. Lightly
turn until the locking lugs on the dust container sit correctly
in the recesses on the motor unit. Rotate the dust container
clockwise to fi x it into the motor unit. The release button on the
dust container must be located below the suction opening (8)
after it has been attached.
•
Detaching: Press the release button
on the extension tube or on the electri-
cal fl oor nozzle and pull the extension
tube or electrical fl oor nozzle out.