Cleanmaxx PC-P007E Mode D'emploi page 24

EN
Cleaning the Motor Filters
1. Empty the dust container (7) (see "Emptying the Dust Container"). Do not close the
bottom fl ap (21).
2. Remove the foam fi lter from the dust container.
3. Reach into the dust container. Turn the fi lter holder (23) a little until it is released and
can be removed.
22
7. Wipe out the dust container with a damp cloth if necessary.
8. Let all parts dry completely in the air before you reassemble them. IMPORTANT:
Never assemble wet or damp components or attach them to the motor unit (3)!
The device is assembled in the reverse order.
Cleaning the Motor Unit and Accessories
• Wipe off the motor unit (3), the extension tube (11) and the nozzles with a soft, moist
cloth as needed. Then dry it with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
• Remove the dust cloth from the dusting mop (16) and wash it as per the washing
instructions. Please note: Do not use fabric softener. Wash separately or with the
same colours.
Cleaning the Electrical Floor Nozzle
To make it easier to clean, the brush can be removed from the electrical fl oor nozzle (9):
4. Pull the HEPA fi lter (22) out of the fi lter holder.
5. Tap out the fi lter and the fi lter holder and clean them with
23 a soft brush if necessary.
6. Rinse the fi lter holder with clear water. IMPORTANT: Do
not use water to clean the HEPA fi lter or the foam fi lter!
1. Slide the latch fastener on the bottom of the electrical fl oor
nozzle towards the small wheel.
2. Open the latch and remove.
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end
with the star-shaped recess.
5. Insert the latch and slide the latch fastener back in place.
24