Table des Matières
Publicité
134
6-1
6-2
1
6-3
1
6-4
Maintenance
6.0 Maintenance
This unit is designed to operate for a long time.
If the operator shuts down correctly (
end of each shift, no further maintenance is required.
This unit must not be opened by the operator, except
in accordance with explicit instructions.
6.1
Compensation Run
All clamping and centring means are balanced in our
works to within a certain tolerance.
To compensate for any residual unbalance that might
be left in the clamping means, it is recommended
that an electrical compensation run be performed
after switching on the machine or after changing
the wheel adaptor, especially a motorcycle wheel
adaptor (also see § 5.2.3).
This mode cannot be transferred into the permanent
memory.
• Fit the clamping device properly on the balancer
shaft (Fig. 6-1). Do not fit the wheel.
• Starting from the screen main menu (Fig. 6-2) press
the key for electrical compensation of unbalance in
clamping means (1, Fig. 6-2).
• Start the compensation run with the START key
(Fig. 6-3).
The compensation run takes longer than a regular
measuring run. After the Compensation Run, an
icon in the status Bar indicates the Compensation
Active status.
This mode of operation is retained until deleted
by pressing key (1, Fig. 6-4) again, by starting
readjustment or an optimisation run, or by switching
off the machine.
5.1.3) at the
Publicité
Table des Matières
Dépannage
