Maintenance - Hofmann monty 3550 Notice D'utilisation

40
monty 3550 / 3550AIR
6.0-1
6.0-2
6.0-3

6.0 maintenance

WARNING
BEFORE ATTEMPING ANY MAINTENANCE OR
REPAIRS THE MACHINE MUST BE DISCONNECTED
FROM THE AIR AND ELECTRIC SUPPLY.
A. Periodically clean the vertical hexagonal rod with
nonflammable liquid detergent. Lubricate with oil (Fig. 5.4).
B. Periodically clean all moving metal parts and lubricate
with oil.
C. Clean the teeth of the clamps with a wire brush, check
the plastic rim protectors and replace if worn (Fig. 5.5).
D. Peridically replaced the plastic insert inside mount/
XXXX.tif
demount tool.
E. Lubricate rods of air cylinders with oil as needed.
F. Periodically wash all plastic parts with cold water and
soap or window cleaner.
G. Check the bead breaker pads. Replace if worn.
H. Discharge the water every day from air filter
I. The machine is equipped with an automatic lubricator.
Check the oil level weekly.
When adding oil to the lubricator, disconnect the air supply
first, remove the fill screw 'A', and add oil as needed. Make
sure seals are in place when repositioning the cup
Drain water daily from water separator. Do this by pulling
1063.tif
down the fitting 'B' (Fig. 5.6).
WARNING!
PAY ATTENTION TO KEEP FILLED THE OIL TANK
OF THE OILER, EXPECIALLY FOR AIR MOTOR
OPERATED MACHINES.
WARNING!
USE ONLY OILS FOR AIR DEVICES, DO NOT USE
BRAKE FLUID OR OTHER NOT SUGGESTED
LUBRICANTS.
Suggested oils for the filter/lubricator unit:
10W Non detergent / Air tool oil.
1059.tif
USA - CANADA