Hofmann geodyna 7850p Mode D'emploi page 160

A
1
1
160
1
7-3
B
2 3
7-4
7-4a
Setting Parameters
7.4 Settings
Normal operation usually does not require any
modification of the factory–adjusted modes of
operation or their factory–adjusted state.
Variations, however, can be made by selecting certain
specific items in the SETTINGS screen.In addition to
the changes made to the functioning modes, from this
menu various counters can be displayed showing the
operations carried out over time by the balancer.
Recalling the SETTINGS screen
 Select the SETTINGS item (1, Fig. 7-3).
The SETTINGS screen Figure 7-4 will open and the
Basic List panel will be immediately active (1, Fig. 7-4),
(CATEGORIES).
The various items can be selected.
An active panel presents an illuminated image of the flange (A).
When an item is selected the panel that contains it
turns a darker colour (B).
CATEGORIES
(1, Figure 7-4)
 Select a Category:
- General settings
- Setting Measurements
- Network and Printer connections
- Counters
- System information
This takes you to the central PARAMETERS panel
(2, Fig. 7-4).
PARAMETERS
(2, Figure 7-4)
 Select a parameter.
The selector shifts to the VALUES panel (3, Fig. 7-4)
so that changes can be made or information acquired.
VALUES
(3, Figure 7-4)
 Select the desired item.
Note:
Values cannot be changed in the Counters or
Information categories.
 Press again to return to the HOME screen (1, Fig.
7-4a).
* = Factory adjusted mode