General Technical Data; Sound Level - Pfaff BETA BGV C1 Mode D'emploi

Electric wire rope winch >BETA II< BGV C1
English
for stages and studios

2.3 General technical data

FEM Group acc. to DIN 15020
type of operation (acc. to VDE 530)
max. permissible operations per hour
type of protection
suitable for ambient temperature
Motor connection
at 50 Hz
P ≤
3,0 kW
P >
3,0 kW
Motor:
connecting voltage
Brake:
coil voltage
1)
before taking into operation see page 21
Electric wire rope winch >BETA< BGV C1 as special design
If the winch is supplied as special design (not complete) respective without electric control (electric
control respective parts of the lifting hoist are provided on site) the manufacturer of the entire instal-
lation takes the responsibility for the tests.
Indications for electric control, limit switch, overload protection and electric installation are only for
information, and are designed as project help for provided on site electric control.
Special design
Type
Specific technical data for special design see annexed data sheet!
The basic design winch corresponds to the tested design
Test certificate no. 03 041
When the controls, or controls with a frequency converter are equipped on site, the on-site designer
is responsible for creating the wiring diagram and selecting the equipment to integrate.
Depending on the requirements, the following can be integrated into the electrical controls:
– Overload protection respective electronic overload protection
– Brake resistance
– Brake drive
– Limit switch
– Emergency limit switch
– regulation and monitoring device
– maximum speed monitoring
The final selection falls under the manufacturer's responsibility for the entire system.
The final selection falls under the manufacturer's responsibility for the entire system.
Prior to commissioning, the entire system must be tested and approved by a field expert on behalf
of the manufacturer.
technische Änderungen vorbehalten
2m
S3 - 40%
120
IP 54
-20°C÷ +40°C
1)
60 Hz
3,6 kW Y
∆
3,6 kW
380-420 V ±5% 50 Hz
U ~
440-460 V ±5% 60 Hz
U - 170 ÷ 200 V DC
design changes under reserve
04.01.411

Sound level

The max. sound level [dB(A)] depends upon
the driving power as per following diagram.
driving power [kW]
changements techniques sous réserve
Seite / page 24