Recording The Geo-Data Of The Planned Joint - Hürner HST 300 Print+ 2.0 Manuel Utilisateur

configuration menu.

6.7 Recording the Geo-data of the Planned Joint

This section applies only to the product version with GPS module.
Provided that geo-data recording is enabled in the con-
figuration menu (see Sect. 10.2), the geographic coordi-
nates can be recorded, if the GPS module is on, as soon as
Display 12 shows on the screen.
Wait at least 1 minute from switching the GPS
module on to the actual recording of the geo-data,
or the GPS module will throw a not-ready error.
Important
During the first minute after switching the GPS module
on the following messages may appear on the screen: "No
signal," "GPS module failed," "GPS Error, Restarting," and
"GPS Module not Ready." These are no errors during the
starting minute of initialization right after switching on.
If they appear after this time, they have to be considered
actual error messages. In this case, the restart after a GPS
(signal processing) error will be performed by the module
itself, without any user action. The Not Ready message
disappears automatically, too, as soon as the module is
ready for recording.
The geo-data are recorded after you selected "Yes" in
Display 12 using the ñ and ò arrow keys and confirmed
this selection by pressing the START/SET key. A message
confirms that the data have been recorded. The recorded
data then show on the screen (see Display 13). A second
screen is used to display additional information on the
precision at the time of recording. To switch back and forth
between both geo-data screens, press the ð key.
If it is likely that no satisfactorily precise position will be
recorded because of relatively poor signal strength, a warn-
ing message tells you, after you pressed the START/SET
key in Display 12, "Poor GPS signal; record data?". When
this message is showing, you can still start recording the
position by pressing the START/SET key or go on without
recording by pressing the STOP/RESET key.
The recorded position is the one the GPS module
is at at the moment of recording. This means that
in situations where the welding unit cannot be set
Info
next to the joint that is being welded, it is possible
to start by placing the welder/the GPS module next
to the future joint, then to record the geo-data,
and finally to move the welder to the place where
it will be during the welding process.
16
EN
HÜRNER HST 300 Print + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Record Geo-Data
>Yes
No
Current Position
050·38,4873'N
008·59,4141'E
Sat:7
Version August 2016
Display 12
Display 13