Power Supply Failure At Last Welding; Technical Specifications; Service And Repair Contact - Hürner HST 300 Print+ 2.0 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany

11.2.10 Power Supply Failure at Last Welding

The last welding is incomplete. The welding unit was dis-
connected from the power supply voltage while it was
in progress. To go on using the unit, this error has to be
acknowledged by pressing the STOP/RESET key (see also
Sect. 9.4).
12 Technical Specifications
Nominal Voltage
Frequency
Power
Power
Ingress Protection
Primary Current
Ambient Temperature
Output Voltage
Max. Output Current
Memory for Welding Reports 10,000 reports
Data Interface Port
(see also the information on the data ports in Sect. 6)
Tolerances:
Temperature
Voltage
Current
Resistance
Operating Range
Operating Range
13

Service and Repair Contact

HÜRNER Schweisstechnik
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Web: www.huerner.de
We reserve the right to change technical specs of
the product without prior notice.
Info
Version August 2016
230 V
50 Hz / 60 Hz
3295 VA / 2800 VA,
80% duty cy.
3680 VA / 3312 VA,
80% duty cy.
(1)
IP 54
max. 16 A
– 20°C to + 60 °C
(– 4°F to + 140°F)
8 V - 48 V
110 A
USB v 2.0 (480 mbit/s)
± 5 %
± 2 %
± 2 %
± 5 %
20 through 1200 mm
20 through 1600 mm
Tel.: +49 (0)6401 9127 0
Fax: +49 (0)6401 9127 39
E-mail: info@huerner.de
HÜRNER HST 300 Print + 2.0 User's Manual
(1)
Boost System
(1)
27
EN