Remote Operation - Julabo PURA 4 Mode D'emploi

Commissioning
7.2 Operation of the water baths via the USB interface
Input
STATUS
IN_SP_00
IN_PV_00
IN_PV_01
IN_SP_11
IN_MODE_05
OUT_SP_00
OUT_MODE_05
Pos: 17 /T echnische Dokum entation/Flash CORIO/PURA/Alarmm eldungen @ 1\mod_ 146 408 889 985 4_18 .docx @ 97 30 @ 1 @ 1
•
PC and PURA are switched on.
•
Connect the water bath and PC with the USB cable.
For comfortable operation, you can use the JULABO software EasyTEMP.
There are also interface commands to the direct query available:
Function
current operating status
Setpoint query
Current value query
Heating capacity query
Temperature display °C (=0); °F (=1)
Start/Stopp query
Send setpoint
Start/Stop device 1/0

Remote operation

The unit can be remote-controlled via USB interface. For this purpose,
connect the unit via the interface with a PC. Remote operation is
activated and/or deactivated by pressing the
combination (press and hold at the same time for approx. 3 seconds).
During remote operation, the display alternates between the current
bath temperature and "
(membrane) keypad. The unit can be merely deactivated. The set remote
operation is continued after the mains switch is switched on or off.
". The unit cannot be operated using the
-r-
and key
39