Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(8) Left parallel section lengthwise compensation
(9) Needle throwing width of the right bottom of eyelet setting
(10) Needle throwing width of the left bottom of eyelet setting
(11) Needle throwing width setting
(12) Number of stitches of the slant taper bar
Set the length with [RIGHT
key
.
Setting can be performed − 0.6 to 0.6 mm in the
−
increments of 0.1 mm.
＋
•
•
Set the width with [RIGHT
key
. The width can be set within the range of 2.3
±1.0 mm for S type, 2.5 ± 1.0 mm for J type, 2.5 ±
1.0 mm for C type and 2.3 ± 1.0 mm for T type in the
increments of 0.1 mm.
Set the width with [RIGHT
key
. The width can be set within the range of 2.3
±1.0 mm for S type, 2.5 ± 1.0 mm for J type, 2.5 ±
1.0 mm for C type and 2.3 ± 1.0 mm for T type in the
increments of 0.1 mm.
•
•
Set the width with [RIGHT
key
. The width can be set within the range of 2.3
±1.0 mm for S type, 2.5 ± 1.0 mm for J type, 2.5 ±
1.0 mm for C type and 2.3 ± 1.0 mm for T type in the
increments of 0.1 mm.
Set the number of stitches with [RIGHT
[RIGHT
Setting can be performed 2 to 30 stitches within the
range of number of stitches of the taper bar.
Length from the bottom of eyelet to the left
side of parallel section can be adjusted.
] key
Needle throwing width of the right side of
the bottom of eyelet can be set.
Feed base is actuated with the needle
throwing to change the sewing width.
] key
• Needle throwing width of the left side of
the bottom of eyelet can be set.
• Feed base is actuated with the needle
throwing to change the sewing width.
] key
Needle throwing width of the whole
buttonholing can be set.
Feed base is actuated with the needle
throwing to change the sewing width.
] key
Number of stitches of the slant section from
the taper bar to the parallel section can be set.
] key
.
or [RIGHT
]
or [RIGHT
]
or [RIGHT
]
or [RIGHT
]
] key
or
35
Publicité
Chapitres
Table des Matières
