Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(5) Performing threading
WARNING :
Turn OFF the power after operation of steps 1) and 2), and replace needle, thread, cloth cutting
knife or knife holder.
(6) How to use the counter
18
1) Press [THREAD
lights up and the sewing machine stops at the setting
position.
The needle bar rotates by 180˚ and threading
can be performed from the front side.
The presser comes down.
Change the cloth set position (memory switch
No.11=1), and the presser (feed base) moves to
the rear (origin position) when the front set is used.
The cloth cutting drive motor is turned to OFF,
and the cloth cutting dial can be turned by hand.
Display is shown as
In this state, keys other than [THREAD
key
and [RESET
accepted.
2) Press again [THREAD
bar only returns to its home position.
3) Press [RESET
] key
their home positions.
The presser and the feed base operate.
Be careful that hands or fingers are not
being caught in them.
It is recommended to perform installing/removing
the presser unit after operating the aforementioned
step 1) and turning OFF the power.
The counter has been set to UP counter in
the state of delivery.
1) Press [COUNTER
value.
2) Every time the sewing machine completes one
cycle stitching, the value increases by 1 count.
3) The counter value can be changed with [RIGHT
] key
or [RIGHT
4) Press [RESET
] key
value to "0".
The counter can be used as DOWN counter
as well.
(Refer to the item "10. Various functions : (6)
Change-over of the counter" P.43.)
] key
when sewing LED
.
] key
cannot be
] key
and the needle
and
to
return to
] key
to display the counter
] key
.
to return the counter
]
Publicité
Chapitres
Table des Matières
