Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
(5) Installing/removing the presser unit
(6) Attaching the dust bag
6
When moving the feed base by hand, or
removing/attaching the presser unit, be
careful so that the cloth cutting knife does
not come in contact with the holding plates,
orthe thread trimming unit does not come in
contact with the throat plate.
■ How to install
1) Install the presser unit so that presser lever
in the letter "U" of presser base
2) Adjust the hole of presser plate
pin
.
3) Turn clamp holding plate
When installing the presser unit
correctly thread trimming driving arm
roller
into the concave in looper thread
trimming cylinder click
the looper thread trimming unit interferes
with the throat plate during sewing. As a
result, component breakage will be caused.
■ How to remove
1) Turn clamp holding plate
presser plate
.
2) Lifting presser plate
It is comparatively easy to install or remove
the presser unit by moving feed base
the cloth cutting position.
([THREAD
] key is convenient. P.18)
When moving feed base
the aforementioned caution.
Attach dust bag
to clamp
face of the table and insert dust hose
.
to cloth open
to hold presser plate
, insert
. If the roller is off,
to remove from
, remove it so as to draw it.
by hand, follow
located in the rear
into the bag.
fits
.
to
Publicité
Chapitres
Table des Matières
