How To Use The Thread Trimming Counter; Needle Up/Down Compensation Switch - JUKI CP-180 Manuel D'utilisation

校正用

11. HOW TO USE THE THREAD TRIMMING COUNTER

After selecting each item, be sure to perform updating of the function setting No.
When turning OFF the power without performing updating, the set contents are not changed.
For the updating procedure, refer to "18. FUNCTION SETTING SWITCH" p.15.
4) When reset switch 1 is pressed, the contents of indication 2 will be reset to " 0 ".
5) When modifying the count value, increase/decrease the value with setting switch 3 .

12. NEEDLE UP/DOWN COMPENSATION SWITCH

1
Bobbin thread counter indication can be changed
2
over to thread trimming counter (simplified sewing
counter) indication by the operation below.
1) Function setting No. 6 Turn OFF the setting of
2) Function setting No. 14 Turn ON the setting of
3
3) From turning ON the power next, the counter
1
Every time needle up/down compensation switch
1 is pressed, the needle goes up when it is in its
lowest position or comes down when it is in its highest
position. This compensates the stitch by a half of the
predetermined stitch length. However, note that the
machine does not run continuously at a low speed even
if you keep the switch held pressed. Also, note that the
needle up/down compensation switch is inoperative
after turning the handwheel by hand. Sewing of needle
up/down compensation operation does not make the
thread trimming operation operative.
W h e n e v e r p r e s s i n g t h e n e e d l e u p / d o w n
compensation switch 1 and turning ON the power to
the machine, the stop position when the pedal is in
its neutral position can be changed over.
A l s o , t h e s p e c i f i e d s t a t e a t t h i s t i m e c a n b e
confi rmed at the panel.
(The contents shown there will be reflected when
turning ON the power after next time.)
- 13 -
bobbin thread counter function. .
( 0 : off / 1 : on )
sewing counter function.
( 0 : off / 1 : on )
indication works as the thread trimming counter.
Every time thread trimming is performed, the
counter indication is upped.