Setting The Reduction Speed Of Eyelet; Setting The Function F1; Setting The Function F2 - JUKI MEB-3200 Manuel D'utilisation

(12) Setting the reduction speed of eyelet

(13) Setting the FUNCTION F1

−
＋

(14) Setting the FUNCTION F2

The pattern data located in the copy destination are overwritten. So, be careful.
When the pattern No. is changed without pressing [READY
is not performed.
This key can be changed to the key for setting other data by means of the memory switch No. 18.
(Refer to "14. MEMORY SWITCH" p.68.)
Set the reduction speed when the sewing speed
of eyelet section is desired to be reduced.
Set the reduction speed with [RIGHT
[RIGHT ] key .
The speed can be set − 600 sti/min to 0 sti/min in
the increments of 100 sti/min.
• F1 has been set to the switch of knife position
compensation in the state of delivery.
• F1 performs correction of the slip between
the knife position and the sewing position.
1) When the stitches in terms of the knife position are
desired to be placed in the front side, set " ＋ " (plus)
value, and in the rear side, set " − " (minus) value.
2) Set the pattern No. with [RIGHT
[RIGHT ] key .
The knife position compensation can be set − 0.7
mm to 0.7 mm in the increments of 0.1 mm.
This key can be changed to the key for
setting other data by means of the memory
switch No. 17.
(Refer to "14. MEMORY SWITCH" p.68.)
• F2 has been set to the switch of the copy
destination No. in the state of delivery.
• F2 performs copying of the pattern data.
1) When setting the copy destination No. and pressing
[READY ] key, the pattern No. specified in the
copy destination No. is stored in memory.
The original pattern data cannot be changed.
2) Set the pattern No. with [RIGHT
[RIGHT ] key .
The No. can be set 1 to 89.
] key, or turning OFF the power, copying
] key or
] key or
] key or
25