Numatic TTB-1620/100T Mode D'emploi page 28

!
The TTB 1620 / 100T is equipped with a free-wheel function that will enable the operator to move the machine
manually if required.
WHEN THE BRAKE IS DISENGAGED THE MACHINE IS IN FREE-WHEEL MODE
Note:
None of the other functions on the machine will work whilst in the Free Wheel
Remember to re-engage the drive when you reach your final destination / before using the
Free Wheel Function
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL
GROUND BEFORE DISENGAGING BRAKE ARM.
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE
IS ON A SLOPE / GRADIENT
The motor brake is located on the right side of the machine near the rear
wheel (Fig 39).
Fig 39
Pull the arm out (Fig 40).
Fig 40
Swing to the disengaged position (Fig 41).
The motor brake will be fully disengaged.
The machine will now be in full free-wheel mode.
Fig 41
AND HAS NO BRAKE FACILITY.
WARNING!
28
!
Mode!.
machine.