Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PROBLEM
Machine will not operate
Vacuum will not operate
Poor water pick-up
No brush / scrub function
Little or no water flow
Machine just 'stops' while
operating
Failure to rectify the problem or in the event of a breakdown contact your Nacecare dealer
Notes
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
.........................................................................................
Trouble-Shooting
CAUSE
Missing or blown fuses
Key in the 'OFF' position
Low battery charge
Machine is connected and charging
Waste water tank full
Waste-water tank full
Clogged / blocked vacuum hose
Loose hose connections
Debris basket filter cloogged/blocked
Separator filter clogged / blocked
Poor separator seal
Damaged separator seal
Damaged / split vacuum hose
Damaged floor-tool blades
Low battery charge
No brushes fitted
Brush deck raised
Clean-water tank empty
Clean-water tank filter blocked/ clogged
Incorrect water flow setting
Brush deck raised
To much load on the brush system
or the Nacecare Technical helpline +44 (0) 900 1 905 785 0038
( see back page for company addresses or dealers stamp)
SOLUTION
Fit or replace fuse (page 30)
Turn key to 'ON' position (page 22)
Charge batteries (page 29)
Take off charge (page 29)
Empty waste water tank (page 23)
Empty waste-water tank (page 23)
Remove and clean (page 26)
Push tight connections (page 19)
Remove and clean (page 26)
Remove and clean (Page 26)
Clean and refit (page 26)
Renew (contact service dept)
Renew (contact service dept)
Renew (contact service dept)
Recharge batteries (page 29)
Check and fit (page 19)
Lower brush deck (page 22)
Fill clean-water tank (page 20)
Remove and clean (26)
Adjust as desired (Page 22)
Lower brush deck (page 22)
Reset the machine using the key and
decrease the brush load to best suit
the floor type (page 23)
10
Publicité
Table des Matières
