Building In; Technical Data; Disposal Of Packaging And Appliances - Pelgrim IDK830 Notice D'utilisation

Building in

770
510
65
750
490
min.32-
max.40
40
Fig. 12: Built-in dimensions
1. Fit the cable with plug in accordance with the
wiring diagram, and secure the cable using
the strain relief clamp.
2. Saw the opening in the worktop. Do this very
accurately, bearing in mind the built-in
dimensions! Also remove any partitions.
3. Remove the protective foil from the sealing
strip (A) and apply the strip as far out as
possible on the underside of the glass (see
Figure 13).
A
Fig. 13: Sealing strip
4. Lower the hob into the opening.
5. Connect the power supply.
6. Finally, check that the appliance functions
well.
If fault code F9 is displayed, the appliance is
incorrectly connected. The generator(s) is
(are) connected to a 380 volt power supply
(phase-phase).
Check the wiring diagram, or contact the
Service Department.
N.B.: Immediately after the power supply is
connected, the ventilator will switch on. The
appliance performs an autodiagnostic check
lasting several seconds

Technical data

Model number HI 571A
Energy supply 230 V, 50 Hz
Power consumption 5600 W
The model number plate is attached to the base of
the appliance.
This appliance complies with the CE directives.
Disposal of packaging and
appliances
The packaging of the appliance is recyclable. It is
made up of:
cardboard
polyethylene film (PE)
CFC free polystyrene (PS rigid foam)
Please dispose of these materials in a responsible
way in accordance with the regulations of your
local authority.
Your local authority will also be able to give you
information about disposing disused household
appliances in a responsible way.