Cleaning; Faults - Pelgrim IDK830 Notice D'utilisation

Cleaning

While boiled-over food cannot burn in it is
advisable to clean the hotplate immediately after
use.
In order to remove stubborn marks, use a little
mild cleaning agent (e.g. washing up liquid).
Water marks and traces of lime can most easily
be removed with the aid of vinegar. Metallic
traces, usually resulting from sliding the pans
across the ceramic surface, are often difficult to
remove. We suggest you use a suitable cleaning
agent e.g. 'Hob Brite'.
Never use abrasive products which cause fine
scratches where lime traces and dirt can
collect.
Never use sharp objects such as steel wool or
abrasive sponges.

Faults

Please check the following points which may solve the problem, before calling the service department.
Fault Cause
The appliance does not work No power.
and the lamps do not come on.
The cooking zones are not Ambient temperature too low
working, the message F0 (5 °C) before the hob was
appears. plugged in.
The fan switches itself on. The appliance checks itself
after the loss of power.
The appliance stops suddenly. Ventilator is not far enough
open.
The message F7 appears. Overheating of the hob's
electronics.
The lamps continue to flash An unsuitable utensil is being
after switching on. used.
Poor electrical connection.
Remedy
Check the power supply (main
fuse(s), connections).
After installation, wait about ten
minutes. The messages stop
flashing and you can then use
the appliance.
The fan switches itself off.
Check ventilator openings at
front and back.
Allow the appliance to cool
down. Press any button and the
fault code will disappear.
Restart at a lower setting.
Use a suitable utensil (see
page 4).
Check if the cable is being
caught by the drawer. If it is,
have it changed by the installer.