Fitting Your Built-In Hob - Pelgrim GKT814 Notice D'utilisation

INSTALLATION

Fitting your built-in hob

GB 20
Warning!
This appliance must always be earthed.
Installation, maintenance and repairs should only be carried out by
professionals who are authorized by the manufacturer, as failure to do
so will void the warranty.
The appliance should be disconnected from the mains prior to
installation, maintenance or repairs. The appliance is only disconnected
from the mains if:
• the main switch in the house consumer unit is switched off, or
• the fuse for the house consumer unit has been completely
removed, or
• the plug has been pulled out of the socket.
Faulty parts may only be replaced with original Pelgrim parts. Only
those parts are guaranteed by Pelgrim to meet the safety requirements.
If the electrical lead is damaged, it may only be replaced by the
manufacturer, the manufacturer's service organisation or equivalent
qualified persons, in order to avoid dangerous situations.
Preparing the hob
Install the supplied elbow (1/2 "ISO 228 (right)) and sealing ring
to the gas connection of the appliance. Next, using the elbow
(1/2" ISO 10226-1 (conical)), connect the appliance to the gas supply
using a safety hose or a fixed connection.
Cutting out the opening in the work surface
• Saw the opening in the work surface. Do this very carefully
(See "Installation dimensions" on pages 24 and 25).
• If the work surface is made of wood, then coat the sawn surfaces
of the work surface with sealing varnish, to prevent moisture
causing the top to swell.