Time Settings - Comelit PPTZ120IRE Manuel Utilisateur


Protocol: supports pelcoD and pelcoP protocol.

Address: 1-255 (adjustable, default is 1).

Baud Rate: supports Baud rate of 115200 only.
After all parameter settings have been completed, click "Save" and they will come into effect immediately.

Time Settings

Network High Speed Dome

Device Time: set and display the current device time.

Time Zone: different area time format can be selected.

GMT: adjust the time more precisely.

NTP Enable: click to determine whether to use NTP.

Server Address: enter NTP server IP address.

Interval: enter the interval time.

Enable DST: choose to enable or close the DST function; if in the daylight saving time region, just click
daylight saving time.

From: set begin DST time.

To: set end DST time.

DST Bias: set DST offset time.
After all parameter settings have been completed, click "Save" and they will come into effect immediately.
Rev. A
"
Time Settings" interface as shown in the figure below.
Figure 3-17
to enable