2 Hardware Installation
System requirements
LAN or WAN Internet to connect server, via PC Ethernet (network card or network cable) TCP/IP protocol
(Windows/NT/2000/XP) connect, Internet Explorer 9.0 version or later recommended.
Monitor and PC configuration:
CPU: PⅢ or later, RAM: 512M or later (Above DirectX 8.1)
Monitor: 17",1920×1080 resolution
Operating system: Windows NT, Windows2000, Windows XP or later.
Installation environment
Installation environment requirements
Well away from humid or high-temperature environments; choose a site with adequate ventilation; avoid installing on unsteady surfaces, and
try to avoid sources of heat.
Recommended operating environment
-30°C~60°C
Hardware installation steps
Please make sure the LAN and WAN are working in order before installing the Network High Speed Dome. After making sure the entire
network system is in good condition, keep your hands clean and dry and proceed as follows.
Unpack the box to check the goods
Remove all goods needed for installation from the box
Take off the protective cover and insert the micro-SD card. Please refer to the micro-SD card installation steps below.
Rev. A
Figure 2-1
Figure 2-2
Remove the ornament
screws (2pcs), then take
off ornament
Loosen the horizontal
installation panel screws
(4pcs), then pull up the panel
slightly