Network Settings - Comelit PPTZ120IRE Manuel Utilisateur

Network Settings

Network High Speed Dome "Network Settings" interface as shown in the figure below.

IPV4: IP protocol version no. is 4.

Static IP: the device IP address is permanent.
 DHCP: click DHCP: when turning on the router's DHCP, the camera will obtain the IP address from the router automatically.

IP Address: enter the corresponding numbers to change the IP address.

Subnet Mask: enter the corresponding IP subnet mask.

Default Gateway: enter the corresponding gateway address.

DNS 1: DNS server address.

DNS 2: DNS server standby address.

RTSP Port: use the domain name to login and access the device requiring RTSP mapping (default port 554).

RTSP Validation: choose RTSP verification mode: Http-Base64, Http-Digest. Next, click to check and enable the corresponding
RTSP verification mode. When playing an RTSP real-time stream, the user name and password must be verified.

RTMP Port: use the domain name to login and access the device requiring RTMP mapping (default port 1935).

Enable PPPoe: click to enable PPPOE.
Username: enter username.
Password: enter password.
Confirm Pwd: enter the password again to confirm.
PPPoe IP: enter device dynamic address.
After all parameter settings have been completed, click "Save" and they will come into effect immediately.
Rev. A
Figure 3-30