Comelit PPTZ120IRE Manuel Utilisateur page 4

CAUTION

Non-technical personnel should not attempt to operate this high speed dome before reading this manual carefully. (This manual is
subject to change without prior notice.)

Cut the power supply off before working on the device to avoid damage caused by incorrect operation.

The chamber contains precision optical and electrical instruments. Heavy pressure, shock and other incorrect actions should be avoided.
Otherwise, the product may be damaged.

Please do not use the product in circumstances where the maximum specified temperature, humidity or power supply limits are
exceeded.

The content of this manual may differ from the edition that you are using. Should any unsolved problem occur when the product is used
according to this manual, please contact our technical support department or your product supplier.

The content of this manual will be updated without prior notice; our company reserves the right to update the contents of this manual
without further notice.
The default username for this device is "admin" and the password is "blank" (Users can set the password according to the reminder).

The default IP address is 192.168.1.188, HTTP port is 80, device port is 5050. Default communication protocol is pelcoD, baud rate is
115200 BIT/s, and PTZ address is No.1

The device will enable its preheat function when it is cold booting below -20℃; it will take about 30 minutes for the device to begin
operating normally.
 PTZ camera installation grounding lightning protection: ground resistance ≤ 4Ω, ground wire (Olivine copper wire) cross-section ≥ 1.2
mm².